Woodshop Services
Woodshop Services Raleigh
Woodshop Services | Planing | Wide-Belt Sanding | Orbital Sanding | Bandsaw Services
At Oak City Customs, our woodshop has the machines and tooling to assist with your project! We offer woodshop services to the general public, residential and commercial clients! We are located 20 minutes east of Raleigh in Zebulon, NC!Shop Services Hours: 5pm - 6pm Wednesday - Friday | 9am - 5pm Saturday
NORTHTECH™️
52" Double Helical Jointer/Planer
With only a handful produced worldwide, this 192HP machine is the largest on the East Coast, USA! Featuring a 40HP feed, the NorthTech Double Helical Jointer/Planer can save you a ton of time, while ensuring your panel is flat. To learn more about this machine, watch the full video, give us a call, or stop in - we'd love to give you a tour and help with your project!
Pricing
- $1.50 / SQFT (Total SQFT is calculated, including both sides)
- $150 / Hour General Shop Services
- $50 Shop minimum applied when sqft or lnft of items serviced do not reach this total
- $150 Hourly shop rate applied when services take over 30 minutes, unless lnft or sqft of items serviced exceed this rate
TIMESAVERS™️
52" Wide-Belt Finish Sander
This machine really lives up to its name! A true timesaver in our shop with 3 sanding heads, consisting of a 14" rubber segmented contact drum, platen, & platen setup.
This 22,000lb beast is 120hp with a 10hp feed, that depending on sandpaper selection, will generally remove about .03" or 1/32" per pass.
We usually run this machine with 60, 100, & 150-grit paper. Producing a very flat panel, this is normally the last step before entering our hand-finishing process.
Almost everything we make goes through this machine!
Pricing
- $3 / SQFT (Total SQFT is calculated, including both sides)
- $150 / Hour General Shop Services
- $50 Shop minimum applied when sqft or lnft of items serviced do not reach this total
- $150 Hourly shop rate applied when services take over 30 minutes, unless lnft or sqft of items serviced exceed this rate
TIMESAVERS™️
52" Orbital Finish Sander
Our 52" wide Timesavers Orbital Finish Sander is the final machine that our wood panels are process through. This machine features (2) orbital heads, with (2) 6" x 52" orbital sanding pads, a total of 4 pads. In addition to these 4 pads, the machine is equipped with a QuickWood Brush Head. Material will be sanded to 180grit once process with this orbital sander, leaving only hand-sanding and final touches prior to finishing!
Pricing
- $3 / SQFT (Total SQFT is calculated, including both sides)
- $150 / Hour General Shop Services
- $50 Shop minimum applied when sqft or lnft of items serviced do not reach this total
- $150 Hourly shop rate applied when services take over 30 minutes, unless lnft or sqft of items serviced exceed this rate
