Expert Wide Belt Sanding Services in Raleigh, NC

This machine really lives up to its name! A true timesaver in our shop with 3 sanding heads, consisting of a 14" rubber segmented contact drum, platen, & platen setup.

This 22,000lb beast is 120hp with a 10hp feed, that depending on sandpaper selection, will generally remove about .03" or 1/32" per pass.

We usually run this machine with 60, 100, & 150-grit paper. Producing a very flat panel, this is normally the last step before entering our hand-finishing process.

Almost everything we make goes through this machine!

Pricing

• $3 / SQFT (Total SQFT is calculated, including both sides)
• $150 / Hour General Shop Services
• $50 Shop minimum applied when sqft or lnft of items serviced do not reach this total
• $150 Hourly shop rate applied when services take over 30 minutes, unless lnft or sqft of items serviced exceed this rate